[PATCH v3 00/16] Add board support for Spacemit K1 SoC in SPL

[Vincent Legoll]

Hi Guodong Xu,

On 3/27/26 04:10, Guodong Xu wrote:
> Thanks for testing the v3 K1 SPL patchset.
> Actually your result confirms the SPL patchset is working correctly and the
> build/test procedure is generally complete.

OK, thanks for confirming.

> PS: I added some walk through to the key lines in your log below (for you
> and for the community's future reference purpose), but for here please be
> noted that as I said in the doc patch [1]:
>
> "After DDR init succeeds, SPL proceeds to load U-Boot proper. If
>   U-Boot proper is not yet available (as in SPL-only testing), you
>   will see SPL: failed to boot from all boot devices - this is
>   expected and confirms that SPL with DDR init is working correctly."
>
> [1] https://lore.kernel.org/u-boot/20260311073741.80616-1-guodong@riscstar.com/

Yes, I missed that part of your doc, so as Heinrich says in

his comment to the v2, you should move that higher or make

it more obvious to see.


I was expecting to see some of what you had in v1 of the

doc patch, in "Expected Output".


Is there some debug macro to enable that output ?

> Back to the patch series itself, your log is a good validation of
> the v3 SPL patchset.

OK, in this case you can add my:

Tested-by: Vincent Legoll<legoll at online.fr> # BPI-F3 (8GB)

for the next iteration, or directly to this v3 if there

is no further one.