[ELDK] GDB Issue

Nate Jozwiak njozwiak at mlsw.biz
Tue Nov 2 21:27:36 CET 2010


Hi Wolfgang,

I appreciate the reply. I did go through the FAQs and saw that one. I
believe it's exclusive to issues with e500 architectures, am I correct? My
target is not an e500 based system it's the 440 architecture and GDB appears
to be locked into an e500 arch configuration.

Thanks,
Nate

-----Original Message-----
From: Wolfgang Denk [mailto:wd at denx.de] 
Sent: Tuesday, November 02, 2010 16:01 PM
To: Nate Jozwiak
Cc: eldk at lists.denx.de
Subject: Re: [ELDK] GDB Issue

Dear "Nate Jozwiak",

In message <024501cb7abd$a49f1dd0$eddd5970$@biz> you wrote:
>
> I am having an issue getting U-Boot going on a PPC-440GX board. I am using
> the GDB that was built with U-Boot for ppc-4xx and a BDI3000 to connect to
> the target. Whenever I attempt to connect to the BDI3000, I get the
> following error:
> 
>      (gdb) target remote 192.168.4.252:2001
>      Remote debugging using 192.168.4.252:2001
>      Remote 'g' packet reply is too long:deadbeaf....

You hit a FAQ. Please see here:
http://www.denx.de/wiki/view/DULG/ELDKGDBProblemsOnE500

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Computers make excellent and efficient servants, but I have  no  wish
to  serve under them. Captain, a starship also runs on loyalty to one
man. And nothing can replace it or him.
	-- Spock, "The Ultimate Computer", stardate 4729.4



More information about the eldk mailing list