[U-Boot-Users] RE: Trouble booting uboot on 440GX (ocotea) eval board afterinitial power-up boot

Howard, Marc Marc.Howard at KLA-Tencor.com
Sat Nov 13 01:22:23 CET 2004


What works is using a supported flash device.  I had swapped out the AMD
parts for SST 39VF040.  They program like AMDs but the sector sizes are
different.  Putting in the AMDs and re-flashing U-Boot solved the
problem.

Thanks to all,

Marc W. Howard 

-----Original Message-----
From: David Adair [mailto:dadair at ariodata.com] 
Sent: Friday, November 12, 2004 3:47 PM
To: Howard, Marc
Cc: u-boot-users at lists.sourceforge.net
Subject: RE: Trouble booting uboot on 440GX (ocotea) eval board
afterinitial power-up boot



> -----Original Message-----
> On Thu, Nov 11, 2004 at 06:19:02PM -0800, Howard, Marc wrote:
> > Hi,
> >
> > I've built and installed U-Boot 1.1.2 on an IBM 440GX eval board
> > (ocotea).  After powering the board I can get the uboot interactive
> > prompt.  If I type 'reset' or hit the reset button it hangs.  I get
the
> > same results whether or not I use the BDI2000.  Doing a power cycle
of
> > the board is the only way to get back to the prompt.
> >
> > Is there some reconfiguation U-Boot does that causes the processor
boot
> > address to change after the initial power-up?  Am I missing
something
> > here?
> 
> You might find more help on the u-boot users list.
> 
> -Matt

Does resetting the SDRAM controller help?

http://sourceforge.net/mailarchive/forum.php?thread_id=5843422&forum_id=
1289
8







More information about the U-Boot mailing list