[U-Boot-Users] uImage's load address and entry point?

[Shawn]

> > load address and entry point address do NOT depend on which image you
> > use for building the U-Boot image (actually the only choice you  have
> > is  using the raw binary or the compressed raw binary). They depen on
> > your kernel's memory map, and nothing else.
> 
> I noticed that the load address and entry point are all set to
> ${ZRELADDR} in both arch/armnommu/boot/Makefile and
> arch/arm/boot/Makefile. In my case (CM946E and Integrator CP) the
> memory map is as follows.
> 
> 0x00000000    ---    Flash (alias)
> 0x00100000    ---    SDRAM (128M)
> 0x10000000    ---    CM control registers
> 0x24000000    ---    Flash (16M)
> 
> At reset the top 256K (0x24FC0000 - 0x24FFFFFF) of flash is mapped to
> address 0x0.
> 
> So ${ZRELADDR} should be set to 0x00180000, right? Thus the load
> address and entry point are both set to 0x00180000. Right?

Sorry for some typo. I mean {ZRELADDR} should be set to 0x00108000.
{ZRELADDR} always ends with 0x8000 for ARM.

-Shawn.