[U-Boot-Users] Start with u-boot on at91rm9200 on AT91RM9200-EK

[Erdmann, Thomas]

Hello,
for the first step of reproducing a runnig u-boot i use the original Atmel Board.
Here the u-boot does nothing after load with loader.bin.
The Atmel delivered u-boot.bin does normal work.
U-boot is build with the desribed steps without any Error Messages.

make at91rm9200dk_config
make all

Then X-Modem the loader.bin and then X-Modem the u-boot.bin to the AT91RM9200-EK
and after this nothing happens.

Are there further Things to configure, i didn't read ?

THX 
  Thomas

> -----Ursprüngliche Nachricht-----
> Von: wd at denx.de [mailto:wd at denx.de] 
> Gesendet: Mittwoch, 19. Juli 2006 08:52
> An: Erdmann, Thomas
> Cc: u-boot-users at lists.sourceforge.net
> Betreff: Re: AW: [U-Boot-Users] Start with u-boot on 
> at91rm9200 on AT91RM9200-EK 
> 
> In message 
> <F6726C3E89A64840A5E10310E342A38F01BE93C9 at xchback01.back.harti
> ng.intra> you wrote:
> >
> > I don't use a new Hardware for now, i use the original Atmel 
> > AT91RM9200-EK Evaluation Board, which should be supported 
> by Standard 
> > -
> ...
> > > > because of a new Flash Chip i must compile u-boot and in than
> 
> So what? Is this the original hardware, or a modified one?
> 
> 
> And please keep the list on Cc:
> 
> Best regards,
> 
> Wolfgang Denk
> 
> --
> Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
> Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: 
> wd at denx.de Knowledge, sir, should be free to all!
> 	-- Harry Mudd, "I, Mudd", stardate 4513.3
> 
>