[U-Boot-Users] [heur] Re: PPC405EP ethernet problems
Matthias Fuchs
matthias.fuchs at esd-electronics.com
Fri Jun 16 17:26:18 CEST 2006
Hi,
is it possible that you use miiphy_read/write() somewhere in your board
specific code? If so, in which function? Which board is it?
Can you post the code from your board setup that does any network
related stuff?
Matthias
Stalder, Reto schrieb:
> Hi Matthias
>
> Thank you for your quick response! I've tried out your suggestion.
> Unfortunately U-Boot stops while booting, without reaching the command
> prompt. The output is:
>
> ...
> U-Boot 1.1.4 (Jun 16 2006 - 16:45:43)
>
> CPU: AMCC PowerPC 405EP Rev. B at 266.666 MHz (PLB=133, OPB=66, EBC=33
> MHz)
> I2C boot EEPROM disabled
> 16 kB I-Cache 16 kB D-Cache
> DRAM: 8 MB
> FLASH: 16 MB
> In: serial
> Out: serial
> Err: serial
> Net:
> ...
>
> Enabled debug outputs (with defined DEBUG and ET_DEBUG constants) do not
> tell me anything more. What else could I try?
>
> Best regards,
> Reto
More information about the U-Boot
mailing list