[U-Boot] [PATCH 2/2] Add SPI helpers to Sequoia

[Steven A. Falco]

This patch adds SPI helper routines for the Sequoia board.

Signed-off-by: Steven A. Falco <sfalco at harris.com>
---
 board/amcc/sequoia/sequoia.c |   20 ++++++++++++++++++++
 1 files changed, 20 insertions(+), 0 deletions(-)

diff --git a/board/amcc/sequoia/sequoia.c b/board/amcc/sequoia/sequoia.c
index d6668e2..01ddb5e 100644
--- a/board/amcc/sequoia/sequoia.c
+++ b/board/amcc/sequoia/sequoia.c
@@ -26,6 +26,7 @@
 #include <libfdt.h>
 #include <fdt_support.h>
 #include <ppc4xx.h>
+#include <spi.h>
 #include <asm/gpio.h>
 #include <asm/processor.h>
 #include <asm/io.h>
@@ -513,3 +514,22 @@ int post_hotkeys_pressed(void)
 	return 0;	/* No hotkeys supported */
 }
 #endif /* CONFIG_POST */
+
+#if defined(CONFIG_HARD_SPI)
+int spi_cs_is_valid(unsigned int bus, unsigned int cs)
+{
+	return bus == 0 && cs >= 0 && cs < 64;
+}
+
+void spi_cs_activate(struct spi_slave *slave)
+{
+	/* Assumes chip-selects are active-low. */
+	gpio_write_bit(slave->cs, 0);
+}
+
+void spi_cs_deactivate(struct spi_slave *slave)
+{
+	gpio_write_bit(slave->cs, 1);
+}
+#endif /* CONFIG_HARD_SPI */
+
-- 
1.6.0.2