[U-Boot] [PATCH v2] mgcoge make ether_scc.c work with CONFIG_NET_MULTI

[Wolfgang Denk]

Dear Ben,

In message <20081111170728.73ca9b7a at ernst.jennejohn.org> Gary Jennejohn wrote:
> This change is needed for mgcoge because it uses two ethernet drivers.
> 
> Add a check for the presence of the PIGGY board on mgcoge.  Without this
> board networking cannot work and the initialization must be aborted.
> 
> Only allocate rtx once to prevent DPRAM exhaustion.
> 
> Initialize ether_scc.c and the keymile-specific HDLC driver (to be added
> soon) in eth.c.
> 
> Signed-off-by: Gary Jennejohn <garyj at denx.de>

Any comments on this?

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
One does not thank logic.
	-- Sarek, "Journey to Babel", stardate 3842.4