[U-Boot] [PATCH v3 2/2] ppc4xx: Add PPC4xx SPI helpers to Sequoia

[Steven A. Falco]

This patch adds helper routines needed in support of the PPC4xx SPI driver.

Signed-off-by: Steven A. Falco <sfalco at harris.com>
---

Changed CONFIG constant to CONFIG_PPC4xx_SPI.

 board/amcc/sequoia/sequoia.c |   20 ++++++++++++++++++++
 include/configs/sequoia.h    |    4 ++++
 2 files changed, 24 insertions(+), 0 deletions(-)

diff --git a/board/amcc/sequoia/sequoia.c b/board/amcc/sequoia/sequoia.c
index d6668e2..080ee1e 100644
--- a/board/amcc/sequoia/sequoia.c
+++ b/board/amcc/sequoia/sequoia.c
@@ -26,6 +26,7 @@
 #include <libfdt.h>
 #include <fdt_support.h>
 #include <ppc4xx.h>
+#include <spi.h>
 #include <asm/gpio.h>
 #include <asm/processor.h>
 #include <asm/io.h>
@@ -513,3 +514,22 @@ int post_hotkeys_pressed(void)
 	return 0;	/* No hotkeys supported */
 }
 #endif /* CONFIG_POST */
+
+#if defined(CONFIG_PPC4xx_SPI)
+int spi_cs_is_valid(unsigned int bus, unsigned int cs)
+{
+	return bus == 0 && cs >= 0 && cs < 64;
+}
+
+void spi_cs_activate(struct spi_slave *slave)
+{
+	/* Assumes chip-selects are active-low. */
+	gpio_write_bit(slave->cs, 0);
+}
+
+void spi_cs_deactivate(struct spi_slave *slave)
+{
+	gpio_write_bit(slave->cs, 1);
+}
+#endif /* CONFIG_PPC4xx_SPI */
+
diff --git a/include/configs/sequoia.h b/include/configs/sequoia.h
index 9321bdc..417fda1 100644
--- a/include/configs/sequoia.h
+++ b/include/configs/sequoia.h
@@ -236,6 +236,10 @@
 #define CONFIG_SYS_DTT_LOW_TEMP	-30
 #define CONFIG_SYS_DTT_HYSTERESIS	3
 
+/* Define these if you are using the SPI port. */
+#undef CONFIG_HARD_SPI
+#undef CONFIG_PPC4xx_SPI
+
 /*
  * Default environment variables
  */
-- 
1.6.0.2