[U-Boot] [PATCH 3/3] NAND FSL elbc: Use virt_to_phys to determine which bank is in use

[Kumar Gala]

The current code that determines which bank/chipselect is used for a
given NAND instance only worked for 32-bit addresses and assumed
a 1:1 mapping.  This breaks in 36-bit physical configs.

The proper way to handle this is to use the virt_to_phys() and
BR_PHYS_ADDR() routinues to match the 34-bit lbc bus address
with the the virtual address the NAND code uses.

Signed-off-by: Kumar Gala <galak at kernel.crashing.org>
Acked-by: Scott Wood <scottwood at freescale.com>
---
 drivers/mtd/nand/fsl_elbc_nand.c |    6 ++++--
 1 files changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/mtd/nand/fsl_elbc_nand.c b/drivers/mtd/nand/fsl_elbc_nand.c
index 367c7d7..3f318e0 100644
--- a/drivers/mtd/nand/fsl_elbc_nand.c
+++ b/drivers/mtd/nand/fsl_elbc_nand.c
@@ -718,7 +718,7 @@ static void fsl_elbc_ctrl_init(void)
 int board_nand_init(struct nand_chip *nand)
 {
 	struct fsl_elbc_mtd *priv;
-	uint32_t br, or;
+	uint32_t br = 0, or = 0;
 
 	if (!elbc_ctrl) {
 		fsl_elbc_ctrl_init();
@@ -737,11 +737,13 @@ int board_nand_init(struct nand_chip *nand)
 	 * if we could pass more than one datum to the NAND driver...
 	 */
 	for (priv->bank = 0; priv->bank < MAX_BANKS; priv->bank++) {
+		phys_addr_t base_addr = virt_to_phys(nand->IO_ADDR_R);
+
 		br = in_be32(&elbc_ctrl->regs->bank[priv->bank].br);
 		or = in_be32(&elbc_ctrl->regs->bank[priv->bank].or);
 
 		if ((br & BR_V) && (br & BR_MSEL) == BR_MS_FCM &&
-		    (br & or & BR_BA) == (phys_addr_t)nand->IO_ADDR_R)
+		    (br & or & BR_BA) == BR_PHYS_ADDR(base_addr))
 			break;
 	}
 
-- 
1.5.6.5