[U-Boot] [PATCH 5/6] ZOOM2 Add serial support.

Tom Tom.Rix at windriver.com
Fri May 15 23:16:29 CEST 2009


Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 16:28 Thu 07 May     , Tom Rix wrote:
>   
>> Zoom2 serial is in general supplied by one of the 4 UARTS on the debug board.
>> The default serial is from the USB connector on left side of the debug board.
>>
>> +/*
>> + * This the the zoom2, board specific, gpmc configuration for the
>> + * quad uart on the debug board.   The more general gpmc configurations
>> + * are setup at the cpu level in cpu/arm_cortexa8/omap3/mem.c
>> + */
>> +extern void enable_gpmc_config(u32 *gpmc_config, gpmc_csx_t *gpmc_cs_base,
>> +			       u32 base, u32 size);
>> +
>> +static u32 gpmc_serial_TL16CP754C[GPMC_MAX_REG] = {
>> +	0x00011000,
>> +	0x001F1F01,
>> +	0x00080803,
>> +	0x1D091D09,
>> +	0x041D1F1F,
>> +	0x1D0904C4, 0
>> +};
>>  
>>     
> Any chance to have comment at least about these value?
>
> Best Regards,
> J.
>   

I have not gotten a response for a better comment.

Can I have a pass on this ?

Tom



More information about the U-Boot mailing list