[U-Boot] [PATCH 5/6] ZOOM2 Add serial support.

[Jean-Christophe PLAGNIOL-VILLARD]

On 16:16 Fri 15 May     , Tom wrote:
> Jean-Christophe PLAGNIOL-VILLARD wrote:
>> On 16:28 Thu 07 May     , Tom Rix wrote:
>>   
>>> Zoom2 serial is in general supplied by one of the 4 UARTS on the debug board.
>>> The default serial is from the USB connector on left side of the debug board.
>>>
>>> +/*
>>> + * This the the zoom2, board specific, gpmc configuration for the
>>> + * quad uart on the debug board.   The more general gpmc configurations
>>> + * are setup at the cpu level in cpu/arm_cortexa8/omap3/mem.c
>>> + */
>>> +extern void enable_gpmc_config(u32 *gpmc_config, gpmc_csx_t *gpmc_cs_base,
>>> +			       u32 base, u32 size);
>>> +
>>> +static u32 gpmc_serial_TL16CP754C[GPMC_MAX_REG] = {
>>> +	0x00011000,
>>> +	0x001F1F01,
>>> +	0x00080803,
>>> +	0x1D091D09,
>>> +	0x041D1F1F,
>>> +	0x1D0904C4, 0
>>> +};
>>>      
>> Any chance to have comment at least about these value?
>>
>
> I have not gotten a response for a better comment.
>
> Can I have a pass on this ?
ok but add a comment in the code and the commit to explain why you can not
provide comment about these values

Best Regards,
J.