[U-Boot] [PATCH v2] OMAP3: Introduce CONFIG option for power code

[Dirk Behme]

Dear Jean-Christophe,

Jean-Christophe PLAGNIOL-VILLARD wrote:
> On 07:56 Sat 16 May     , Dirk Behme wrote:
>> Some OMAP3 boards need control for external power companion
>> chips. Introduce a CONFIG option for this, to avoid Makefile
>> changes for each board.
>>
>> Signed-off-by: Dirk Behme <dirk.behme at googlemail.com>
>> ---
> IIRC the Revc Change it's companion chip is this code still compatible?

Yes, the code is still compatible. And yes, the companion chip 
changed. And yes, this is quite confusing  ;)  Do you still remember 
what I wrote in one of the other mails "only TI marketing department 
might understand their chip naming"?

What I understood is that revision A & B BeagleBoards used "OEM" 
companion chip you will only get in large quantities and manual is 
NDA. Revision C now uses the "catalogue" device, you will e.g. able to 
get from DigiKey and manual is publically available. So different chip 
names, but compatible.

Recent U-Boot mainline is used on rev B and C boards without any 
difference :)

Best regards

Dirk