[U-Boot] [PATCH 4/5] mpc83xx: mpc8360emds: Use RGMII mode, add workarounds for rev. 2.1 CPUs

[Kim Phillips]

On Wed, 16 Sep 2009 23:21:59 +0400
Anton Vorontsov <avorontsov at ru.mvista.com> wrote:

> This patch fixes various ethernet issues with gigabit links handling
> in U-Boot. The workarounds originally implemented by Kim Phillips for
> Linux kernel.
> 
> Signed-off-by: Anton Vorontsov <avorontsov at ru.mvista.com>
> ---

sorry, can't accept - this breaks r1.1 based boards:

U-Boot 2009.08-00210-g089732e (Sep 18 2009 - 17:25:22) MPC83XX

Reset Status: Software Hard, External/Internal Soft, External/Internal Hard

CPU:   e300c1, MPC8360E, Rev: 1.1 at 528 MHz, CSB: 264 MHz
Board: Freescale MPC8360EMDS
I2C:   ready
DRAM:  256 MB (DDR1, 64-bit, ECC off, 264 MHz)
SDRAM: 64 MB (local bus)
FLASH: 16 MB
In:    serial
Out:   serial
Err:   serial
Net:   FSL UEC0, FSL UEC1
Hit any key to stop autoboot:  0 
=> tftp $loadaddr $uboot     
UEC: PHY is Marvell 88E11x1 (1410cc2)
FSL UEC0: Full Duplex
FSL UEC0: Speed 1000BT
FSL UEC0: Link is up
Using FSL UEC0 device
TFTP from server 192.168.1.1; our IP address is 192.168.1.118
Filename 'kimphill/u-boot.MPC8360EMDS'.
Load address: 0x800000
Loading: T T T T T T T T T T 
Retry count exceeded; starting again
UEC: PHY is Marvell 88E11x1 (1410cc2)
warning: FSL UEC1: timeout on PHY link
FSL UEC0: Link is down

Kim