[U-Boot] Configuring BRGs and BRG input clock on an MPC875

[Mikhail Zaturenskiy]

> Hello, I thought I'd ask here before I go and make a mess of my code:
> what's the easiest way to configure my board to have SMC1 use BRG1,
> SCC4 use BRG2, and make my BRG1 and BRG2 use CLK2 as an input clock?
>
> I looked over the code and it looked like most of this is hard-coded
> in the "serial.c" file to use BRG1 for everything and I think to use
> BRGCLK as the BRG clock source ("serial_setdivisor" function).
>
> My board is similar to the EP88xc by the way.
>
> Thanks,
> Mikhail Zaturenskiy
>

I decided to first try to switch over my BRG1 to use CLK2 as the input
clock, it looks like by default it is using BRGCLK. I modified the
"serial_setdivisor" function in cpu/mpc8xx/serial.c to be the
following (CONFIG_PPC_OPS1 is defined):
*******************************************************************************
static void serial_setdivisor(volatile cpm8xx_t *cp)
{
#if defined CONFIG_PPC_OPS1
	int divisor=(48000000 + 8*gd->baudrate)/16/gd->baudrate; // MZ - CLK2 is 48MHz
#else
	int divisor=(gd->cpu_clk + 8*gd->baudrate)/16/gd->baudrate; // MZ -
note: divisor = 70 or 71 at 130MHz and 115200bps
#endif
	
	if(divisor/16>0x1000) {
		/* bad divisor, assume 50MHz clock and 9600 baud */
		divisor=(50*1000*1000 + 8*9600)/16/9600;
	}

#ifdef CONFIG_SYS_BRGCLK_PRESCALE
	divisor /= CONFIG_SYS_BRGCLK_PRESCALE;
#endif

	if(divisor<=0x1000) {
		cp->cp_brgc1=((divisor-1)<<1) | CPM_BRG_EN;
	} else {
		cp->cp_brgc1=((divisor/16-1)<<1) | CPM_BRG_EN | CPM_BRG_DIV16;
	}

#if defined CONFIG_PPC_OPS1
	cp->cp_brgc1 |= CPM_BRG_EXTC_CLK2; // MZ - this line is an attempt at
switching BRG1 input clock to CLK2
#endif
}
***************************************************************************

However, now my board is stuck in an infinite loop in "serial.c"
function "smc_putc", when it tries to send the first character:
************************************************************
while (rtx->txbd.cbd_sc & BD_SC_READY) {
		WATCHDOG_RESET ();
		__asm__("eieio");
}
***********************************

Anybody have an idea as to what I'm doing wrong? Could there be
something wrong with my CLK2?

Thanks,
Mikhail Zaturenskiy