[U-Boot] [PATCH 1/3] fsl_i2c: Wait for STOP condition to propagate

[Joakim Tjernlund]

>
> Dear Joakim Tjernlund,
>
> In message <1253178437-32398-1-git-send-email-Joakim.Tjernlund at transmode.se> you wrote:
> > After issuing a STOP one must wait until the STOP has completed
> > on the bus before doing something new to the controller.
> >
> > Also add an extra read of SR as the manual mentions doing that
> > is a good idea.
> >
> > Remove surplus write of CR just before a write, isn't required and
> > could potentially disturb the I2C bus.
> >
> > Signed-off-by: Joakim Tjernlund <Joakim.Tjernlund at transmode.se>
> > ---
> >  drivers/i2c/fsl_i2c.c |   12 ++++++++----
> >  1 files changed, 8 insertions(+), 4 deletions(-)
>
> Could you _please_ start adding some version information to your
> patches, and a list of changes between the versions?
>
> Thanks.

Yes, that was a bit sloppy on my part, sorry. What do you want
me to do now?
Resend the whole series or do I get away with it this time?
All but the last patch is in u-boot-i2c testing(by Heiko) repo already.