[U-Boot] [PATCH 1/3] fsl_i2c: Wait for STOP condition to propagate

[Heiko Schocher]

Hello Joakim,

Joakim Tjernlund wrote:
>> Dear Joakim Tjernlund,
>>
>> In message <1253178437-32398-1-git-send-email-Joakim.Tjernlund at transmode.se> you wrote:
>>> After issuing a STOP one must wait until the STOP has completed
>>> on the bus before doing something new to the controller.
>>>
>>> Also add an extra read of SR as the manual mentions doing that
>>> is a good idea.
>>>
>>> Remove surplus write of CR just before a write, isn't required and
>>> could potentially disturb the I2C bus.
>>>
>>> Signed-off-by: Joakim Tjernlund <Joakim.Tjernlund at transmode.se>
>>> ---
>>>  drivers/i2c/fsl_i2c.c |   12 ++++++++----
>>>  1 files changed, 8 insertions(+), 4 deletions(-)
>> Could you _please_ start adding some version information to your
>> patches, and a list of changes between the versions?
>>
>> Thanks.
> 
> Yes, that was a bit sloppy on my part, sorry. What do you want
> me to do now?
> Resend the whole series or do I get away with it this time?
> All but the last patch is in u-boot-i2c testing(by Heiko) repo already.

You mean with last patch, this patch:?

http://lists.denx.de/pipermail/u-boot/2009-September/061187.html

If, so, I think, I add it also to the u-boot-i2c testing branch,
and it is OK for now, but please for further patches, add some
information as Wolfgang suggested.

thanks

bye
Heiko