[U-Boot] [PATCH 1/1] TI OMAP3 Use arm init sequence to initialize i2c

[Dirk Behme]

Hi Heiko,

Heiko Schocher wrote:
> Hello Tom,
> 
> Tom Rix wrote:
>> This changes fixes an early i2c error.
>>
>> It appears that I2C is working because once a read or write
>> error is detected, the omap24xx_i2c driver calls i2c_init
>> inside its error handling check.
>>
>> While it is ok to attempt error handling this way, the boards
>> must not depend on this side effect to initialize it's i2c.
>>
>> Instead of explicitly calling i2c_init for every board, use
>> the generic arm initialization in lib_arm/board.c. By defining
>> the config variable CONFIG_HARD_I2C, the omap3 i2c initialization
>> is included in the init_sequence table.
>>
>> Run tested on Beagle.
>> Compile tested on the omap3's
>>
>> Signed-off-by: Tom Rix <Tom.Rix at windriver.com>
>> ---
> 
> Patch does not apply:

It seems that it applies to u-boot-ti. Is it ok to move it through 
u-boot-ti into mainline?

Best regards

Dirk