[U-Boot] [PATCH] mx51evk: Provide a proper reset for the Ethernet PHY

Stefano Babic sbabic at denx.de
Fri Aug 20 10:31:50 CEST 2010


Fabio Estevam wrote:
> Provide a proper reset for the Ethernet PHY (LAN8700) on the MX51EVK.
> 

Hi Fabio,

> Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
> ---
>  board/freescale/mx51evk/mx51evk.c |    4 ++++
>  1 files changed, 4 insertions(+), 0 deletions(-)
> 
> diff --git a/board/freescale/mx51evk/mx51evk.c b/board/freescale/mx51evk/mx51evk.c
> index 75d642b..70cce55 100644
> --- a/board/freescale/mx51evk/mx51evk.c
> +++ b/board/freescale/mx51evk/mx51evk.c
> @@ -261,6 +261,10 @@ static void power_init(void)
>  
>  	/* Reset the ethernet controller over GPIO */
>  	writel(0x1, IOMUXC_BASE_ADDR + 0x0AC);
> +	udelay(200);
> +	reg = readl(GPIO2_BASE_ADDR + 0x0);
> +	reg |= 0x4000;  /* Set reset line to high*/
> +	writel(reg, GPIO2_BASE_ADDR + 0x0);

I know I am responsible for this usage, because I forget to add some
accessors for the gpio pins - as I see your patch, I have sent a patch
to support it. However, a direct access to registers using offsets is
not allowed in u-boot. If we use some kind of accessors, your code will
be easier to read it. Everything could be changed as (0X4000 --> gpio
46, if I am not wrong):

	udelay(200);
	mxc_gpio_set(46);

What do you think ?

Best regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================


More information about the U-Boot mailing list