[U-Boot] Sequoia EHCI

[Chris Zhang]

> I don't know of an ehci-ppc4xx.c file. Did you create it yourself?

I created the file by myself. But it's nothing more than setting up register base addresses similar with ehci-ixp4xx.c ...

I checked out from current source a few days ago. Maybe it's not very straight forward to get ppc4xx  support working (as I originally thought). I'll take a look later this week.

thanks,

Chris

----- Original Message -----
From: "Stefan Roese" <sr at denx.de>
To: u-boot at lists.denx.de
Cc: "Chris Zhang" <chris at seamicro.com>
Sent: Sunday, January 3, 2010 9:45:04 PM
Subject: Re: [U-Boot] Sequoia EHCI

Hi Chris,

On Saturday 02 January 2010 23:25:50 Chris Zhang wrote:
> I was trying to get EHCI running on sequoia board (ppc440epx).

EHCI is currently not supported in U-Boot for PPC4xx.
 
> I'm getting the following message when issuing "usb start" .
> 
> 
> 
> Cannot enable port 1 after 5 retries, disabling port.
> 
> Maybe the USB cable is bad?
> 
> Cannot reset port 1!?
> 
> 1 USB Device(s) found
> 
>                 Scanning bus for storage devices. 0 Storage Device(s)
> found
> 
> =>
> 
> 
> 
> EHCI works fine under operating system (a customized NetBSD). This is the
> configuration I'm using,
> 
> .
> 
> #define CONFIG_USB_EHCI
> 
> #define CONFIG_USB_EHCI_PPC4XX     /* added ehci-ppc4xx.c similar as
> ehci-ixp4xx.c */

I don't know of an ehci-ppc4xx.c file. Did you create it yourself?
 
Cheers,
Stefan

--
DENX Software Engineering GmbH,      MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich,  Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: office at denx.de