[U-Boot] uboot.bin for smdkc100_config fails to boot from NAND

Scott Wood scottwood at freescale.com
Wed Jan 13 19:19:09 CET 2010


On Wed, Jan 13, 2010 at 03:21:50PM +0530, Naveen Krishna Ch wrote:
> Hi All,
> 
> I have a SMDKC100 boards with Single chip NAND
> 
> Built the mainline uboot for
> 
> Das U-Boot# smdkc100_config; make
> 
> i use a In-Circuit Debugger to flash the uboot.bin
> to the NAND.
> 
> I checked the dip switches & Jumpers are proper.
> 
> The In-Circuit Debugger shows "Emulation running"
> But, nothing comes up on the UART0
> 
> What could be the problem, Any pointers..

Does this chip/board have special hardware/ROM to load a full u-boot image
out of NAND into somewhere it can execute?

If not, you'll need nand_spl support for this board.

-Scott


More information about the U-Boot mailing list