[U-Boot] [PATCH 3/3] tqm85xx: Update PCI code

Wolfgang Denk wd at denx.de
Wed Oct 27 08:47:26 CEST 2010


Dear Peter Tyser,

In message <1288156533.1971.6.camel at ptyser-laptop> you wrote:
>
> Can you send the entire bootup output?  The code is based on Freescale
> reference boards, eg the mpc8568mds, so I'd guess the problem is not
> tqm85xx-specific.

Sure. Here it is:

U-Boot 2010.09-00558-g79e6313 (Oct 26 2010 - 21:31:41)

CPU:   8555E, Version: 1.1, (0x80790011)
Core:  Unknown, Version: 2.0, (0x80200020)
Clock Configuration:
       CPU0:833.333 MHz, 
       CCB:333.333 MHz,
       DDR:166.667 MHz (333.333 MT/s data rate), LBC:41.667 MHz
CPM:   333.333 MHz
L1:    D-cache 32 kB enabled
       I-cache 32 kB enabled
Board: TQM8555, serial# ABC0555 casl=25
I2C:   ready
DRAM:  128 MiB
FLASH: 128 MiB
L2:    256 KB already enabled

   PCI1:  32 bit, 33 MHz, sync, host, arbiter
               Scanning PCI bus 00
    PCIE1 on bus 00 - 00
PCI-X will only work at 66 MHz
In:    serial
Out:   serial
Err:   serial
DTT:   1 is 41 C
Net:   FCC1, TSEC0 [PRIME], TSEC1
PS/2:  No device found
Kbd:   reset failed, no ACK

Type run flash_nfs to mount root filesystem over NFS

Hit any key to stop autoboot:  0 
=> 


Please also note the "Core:  Unknown" which is new.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
Hiring experienced unix people is  like  a  built-in  filter  against
idiots. Hiring experienced NT people provides no such guarantee.
            -- Miguel Cruz in WgL96.349$CC.122704 at typhoon2.ba-dsg.net


More information about the U-Boot mailing list