[U-Boot] [PATCH V3 0/5] i.mx: add the initial i.mx6q core/board support

[Stefano Babic]

On 25/11/2011 11:18, Jason Liu wrote:
> This patch-set add the initial support for freescale i.mx6q support.
> freescale i.mx6q is a quad core built on arm cortex_a9 complex.
> 
> The patch-set has been tested ok on freescale i.mx6q Armadillo2 board and also
> make sure it does not break i.mx5 support
> 
> The v1 patch-set has also been tested Ok by: Dirk Behme
> Tested-by: Dirk Behme <dirk.behme at de.bosch.com>
> 
> The patch-set is based on Stefano's uart clean up patch:
> http://patchwork.ozlabs.org/patch/127115/

Jason,

I have no open issues with your patches. I have applied them (at the
moment) to u-boot-imx, next branch.

I know that the patches were sent after the patches window was closed.
However, they do not introduce so big changes to current IMX code, as
MX5 did in the past, and I will not be against to merge them into the
master branch in the next pull request, if nobody complains about it.

Best regards,
Stefano babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-0 Fax: +49-8142-66989-80  Email: office at denx.de
=====================================================================