[U-Boot] New Oxford Semiconductor board with assertion fail in linker

[Michael Kebe]

On Mon, Dec 19, 2011 at 23:26, Michael Kebe <michael.kebe at gmail.com> wrote:
> Thanks, for the hint! There is TEXT_BASE = 0x60d00000.
>
> Here is the output from a bootup of the old U-Boot:
> --------------------
> Stage-1 Bootloader Tue Aug  9 16:44:00 CST 2011
> Attempting to set PLLA to 750MHz ...
>  plla_ctrl0 : 0x0000000A
>  plla_ctrl1 : 0x000F0000
>  plla_ctrl2 : 0x001D01A0
>  plla_ctrl3 : 0x00000017
> PLLA Set
>
> Setup memory, testing
> Reading NAND, Image 0
>  Hdr len: 0x0001A94C
>  Hdr CRC: 0xF0019DAC
>  OK
>
>
> U-Boot 1.1.2 (Jun 24 2011 - 09:41:57)
>
> U-Boot code: 60D00000 -> 60D1A94C  BSS: -> 60D1F004
> RAM Configuration:
>        Bank #0: 60000000 128 MB
> SRAM Configuration:
>        64KB at 0x50000000
> NAND:128 MiB
> In:    serial
> Out:   serial
> Err:   serial
> Setting Linux mem= boot arg value
> Hit any key to stop autoboot:  0
> --------------------
>
> Is the "U-Boot code" the address CONFIG_SYS_UBOOT_BASE should be set
> to? If so, then both addresses are the same, is that ok?

Thanks for the discussion about how to port a new board into U-Boot.
But I think these questions are forgotten, any further hints?