[U-Boot] [PATCH 1/2] powerpc/85xx: CONFIG_ENABLE_36BIT_PHYS does not depend on CONFIG_PHYS_64BIT

[Timur Tabi]

The macro CONFIG_ENABLE_36BIT_PHYS is used to indicate that the given SOC is
capable of 36-bit physical addresses, even if such large addresses are not
used.  On two boards, this macro was enabled only when building a 36-bit
image.

Signed-off-by: Timur Tabi <timur at freescale.com>
---
 include/configs/P1022DS.h      |    3 ++-
 include/configs/p1_p2_rdb_pc.h |    3 +--
 2 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/include/configs/P1022DS.h b/include/configs/P1022DS.h
index a3cccf4..28848bd 100644
--- a/include/configs/P1022DS.h
+++ b/include/configs/P1022DS.h
@@ -43,8 +43,9 @@
 #define CONFIG_FSL_PCIE_RESET		/* need PCIe reset errata */
 #define CONFIG_SYS_PCI_64BIT		/* enable 64-bit PCI resources */
 
-#ifdef CONFIG_PHYS_64BIT
 #define CONFIG_ENABLE_36BIT_PHYS
+
+#ifdef CONFIG_PHYS_64BIT
 #define CONFIG_ADDR_MAP
 #define CONFIG_SYS_NUM_ADDR_MAP		16	/* number of TLB1 entries */
 #endif
diff --git a/include/configs/p1_p2_rdb_pc.h b/include/configs/p1_p2_rdb_pc.h
index b9b89cf..df1925f 100644
--- a/include/configs/p1_p2_rdb_pc.h
+++ b/include/configs/p1_p2_rdb_pc.h
@@ -204,9 +204,8 @@
 #define CONFIG_BTB
 
 #define CONFIG_BOARD_EARLY_INIT_F	/* Call board_pre_init */
-#ifdef CONFIG_PHYS_64BIT
+
 #define CONFIG_ENABLE_36BIT_PHYS
-#endif
 
 #ifdef CONFIG_PHYS_64BIT
 #define CONFIG_ADDR_MAP			1
-- 
1.7.3.4