[U-Boot] u-boot-1.3.3 SMC91111 driver

[Simon Schwarz]

Hi,

first thing would be to use a current U-Boot Version. This can be
obtained from:
http://www.denx.de/wiki/U-Boot/SourceCode

Regards
Simon

On 09/15/2011 03:31 PM, Chaney Lee wrote:
> hello:
> 
> I need your advise.
> I port the u-boot-1.3.3 to my PXA270 board。Every thing  works well but the
> SMC91111 dirver.I have aready config the config file like this:
> #define CONFIG_DRIVER_SMC91111      1
> #define CONFIG_SMC91111_BASE        0x10000300
> #define CONFIG_SMC91111_EXT_PHY
> 
>   #define CONFIG_SMC_USE_32_BIT       1
> Then I use PING command to my host and the minicom shows the host is not
> alive.But I am sure the host  is right because I had PING the host ,which is
> in VMware.
> And after I turn on the DEBUG of SMC91111.c  to 5 ,I get the message.Here
> are part of them.
> 
> SMC91111: smc_hardware_send_packet
> SMC91111: memory allocation, try 1 failed ...
> SMC91111: memory allocation, try 2 failed ...
> SMC91111: memory allocation, try 3 failed ...
> SMC91111: memory allocation, try 4 failed ...
> SMC91111: memory allocation, try 5 failed ...
> 
> So how can I fix this problem?Can you give me some suggestions?
> ps:my u-boot run in RAM and boot from BLOB.Then the u-boot.bin skip the
> lowlevel_init function.
> 
> Thank you !
> 
> 
> 
> 
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot