[U-Boot] u-boot-1.3.3 SMC91111 driver

[Marek Vasut]

On Thursday, September 15, 2011 03:53:02 PM Simon Schwarz wrote:
> Hi,
> 
> first thing would be to use a current U-Boot Version. This can be
> obtained from:
> http://www.denx.de/wiki/U-Boot/SourceCode

Try not top-posting please.

btw. the lowlevel init function also configures the hardware, maybe you should 
remove blob and replace it with uboot ... and use mainline version, like Simon 
suggested, 1.3.3 is _way_ too old.

Cheers

> 
> Regards
> Simon
> 
> On 09/15/2011 03:31 PM, Chaney Lee wrote:
> > hello:
> > 
> > I need your advise.
> > I port the u-boot-1.3.3 to my PXA270 board。Every thing  works well but
> > the SMC91111 dirver.I have aready config the config file like this:
> > #define CONFIG_DRIVER_SMC91111      1
> > #define CONFIG_SMC91111_BASE        0x10000300
> > #define CONFIG_SMC91111_EXT_PHY
> > 
> >   #define CONFIG_SMC_USE_32_BIT       1
> > 
> > Then I use PING command to my host and the minicom shows the host is not
> > alive.But I am sure the host  is right because I had PING the host ,which
> > is in VMware.
> > And after I turn on the DEBUG of SMC91111.c  to 5 ,I get the message.Here
> > are part of them.
> > 
> > SMC91111: smc_hardware_send_packet
> > SMC91111: memory allocation, try 1 failed ...
> > SMC91111: memory allocation, try 2 failed ...
> > SMC91111: memory allocation, try 3 failed ...
> > SMC91111: memory allocation, try 4 failed ...
> > SMC91111: memory allocation, try 5 failed ...
> > 
> > So how can I fix this problem?Can you give me some suggestions?
> > ps:my u-boot run in RAM and boot from BLOB.Then the u-boot.bin skip the
> > lowlevel_init function.
> > 
> > Thank you !
> > 
> > 
> > 
> > 
> > _______________________________________________
> > U-Boot mailing list
> > U-Boot at lists.denx.de
> > http://lists.denx.de/mailman/listinfo/u-boot
> 
> _______________________________________________
> U-Boot mailing list
> U-Boot at lists.denx.de
> http://lists.denx.de/mailman/listinfo/u-boot