[U-Boot] [PATCH] mx6qsabrelite: No need to set the direction for GPIO3_23 again

Fabio Estevam festevam at gmail.com
Wed Apr 11 22:22:24 CEST 2012


There is a 'gpio_direction_output(87, 0);' call previously, so the GPIO direction is 
already established.

Use gpio_set_value() for changing the GPIO output then.

Signed-off-by: Fabio Estevam <fabio.estevam at freescale.com>
---
 board/freescale/mx6qsabrelite/mx6qsabrelite.c |    2 +-
 1 files changed, 1 insertions(+), 1 deletions(-)

diff --git a/board/freescale/mx6qsabrelite/mx6qsabrelite.c b/board/freescale/mx6qsabrelite/mx6qsabrelite.c
index 1d09a72..2155d87 100644
--- a/board/freescale/mx6qsabrelite/mx6qsabrelite.c
+++ b/board/freescale/mx6qsabrelite/mx6qsabrelite.c
@@ -135,7 +135,7 @@ static void setup_iomux_enet(void)
 
 	/* Need delay 10ms according to KSZ9021 spec */
 	udelay(1000 * 10);
-	gpio_direction_output(87, 1);  /* GPIO 3-23 */
+	gpio_set_value(87, 1);  /* GPIO 3-23 */
 
 	imx_iomux_v3_setup_multiple_pads(enet_pads2, ARRAY_SIZE(enet_pads2));
 }
-- 
1.7.1



More information about the U-Boot mailing list