[U-Boot] [PATCH] mx6qsabrelite: No need to set the direction for GPIO3_23 again

[Dirk Behme]

On 11.04.2012 22:22, Fabio Estevam wrote:
> There is a 'gpio_direction_output(87, 0);' call previously, so the GPIO direction is
> already established.
>
> Use gpio_set_value() for changing the GPIO output then.
>
> Signed-off-by: Fabio Estevam<fabio.estevam at freescale.com>
> ---
>   board/freescale/mx6qsabrelite/mx6qsabrelite.c |    2 +-
>   1 files changed, 1 insertions(+), 1 deletions(-)
>
> diff --git a/board/freescale/mx6qsabrelite/mx6qsabrelite.c b/board/freescale/mx6qsabrelite/mx6qsabrelite.c
> index 1d09a72..2155d87 100644
> --- a/board/freescale/mx6qsabrelite/mx6qsabrelite.c
> +++ b/board/freescale/mx6qsabrelite/mx6qsabrelite.c
> @@ -135,7 +135,7 @@ static void setup_iomux_enet(void)
>
>   	/* Need delay 10ms according to KSZ9021 spec */
>   	udelay(1000 * 10);
> -	gpio_direction_output(87, 1);  /* GPIO 3-23 */
> +	gpio_set_value(87, 1);  /* GPIO 3-23 */
>
>   	imx_iomux_v3_setup_multiple_pads(enet_pads2, ARRAY_SIZE(enet_pads2));
>   }

Acked-by: Dirk Behme <dirk.behme at googlemail.com>

Thanks

Dirk