[U-Boot] [PATCH V3] i.MX6: mx6q_sabrelite: add SATA bindings
Eric Nelson
eric.nelson at boundarydevices.com
Thu Apr 26 01:50:01 CEST 2012
Signed-off-by: Eric Nelson <eric.nelson at boundarydevices.com>
---
V2 has been stripped of the board-independent changes and
uses clrsetbits_le32() instead of twiddling bits by hand.
V3 returns immediately from setup_sata() if enable_sata_clock()
returns an error.
board/freescale/mx6qsabrelite/mx6qsabrelite.c | 32 +++++++++++++++++++++++++
include/configs/mx6qsabrelite.h | 13 ++++++++++
2 files changed, 45 insertions(+), 0 deletions(-)
diff --git a/board/freescale/mx6qsabrelite/mx6qsabrelite.c b/board/freescale/mx6qsabrelite/mx6qsabrelite.c
index 1d09a72..c9a108f 100644
--- a/board/freescale/mx6qsabrelite/mx6qsabrelite.c
+++ b/board/freescale/mx6qsabrelite/mx6qsabrelite.c
@@ -25,6 +25,8 @@
#include <asm/arch/imx-regs.h>
#include <asm/arch/mx6x_pins.h>
#include <asm/arch/iomux-v3.h>
+#include <asm/arch/ccm_regs.h>
+#include <asm/arch/clock.h>
#include <asm/errno.h>
#include <asm/gpio.h>
#include <mmc.h>
@@ -267,6 +269,32 @@ int board_eth_init(bd_t *bis)
return 0;
}
+#ifdef CONFIG_CMD_SATA
+
+int setup_sata(void)
+{
+ struct iomuxc_base_regs *const iomuxc_regs
+ = (struct iomuxc_base_regs *) IOMUXC_BASE_ADDR;
+ int rval = enable_sata_clock();
+ if (rval)
+ return rval ;
+
+ clrsetbits_le32(&iomuxc_regs->gpr[13],
+ IOMUXC_GPR13_SATA_MASK,
+ IOMUXC_GPR13_SATA_PHY_8_RXEQ_3P0DB
+ |IOMUXC_GPR13_SATA_PHY_7_SATA2M
+ |IOMUXC_GPR13_SATA_SPEED_3G
+ |(3<<IOMUXC_GPR13_SATA_PHY_6_SHIFT)
+ |IOMUXC_GPR13_SATA_SATA_PHY_5_SS_DISABLED
+ |IOMUXC_GPR13_SATA_SATA_PHY_4_ATTEN_9_16
+ |IOMUXC_GPR13_SATA_PHY_3_TXBOOST_0P00_DB
+ |IOMUXC_GPR13_SATA_PHY_2_TX_1P104V
+ |IOMUXC_GPR13_SATA_PHY_1_SLOW);
+
+ return 0 ;
+}
+#endif
+
int board_early_init_f(void)
{
setup_iomux_uart();
@@ -283,6 +311,10 @@ int board_init(void)
setup_spi();
#endif
+#ifdef CONFIG_CMD_SATA
+ setup_sata();
+#endif
+
return 0;
}
diff --git a/include/configs/mx6qsabrelite.h b/include/configs/mx6qsabrelite.h
index f52c3c7..1d92dd0 100644
--- a/include/configs/mx6qsabrelite.h
+++ b/include/configs/mx6qsabrelite.h
@@ -71,6 +71,19 @@
#define CONFIG_CMD_FAT
#define CONFIG_DOS_PARTITION
+#define CONFIG_CMD_SATA
+/*
+ * SATA Configs
+ */
+#ifdef CONFIG_CMD_SATA
+#define CONFIG_DWC_AHSATA
+#define CONFIG_SYS_SATA_MAX_DEVICE 1
+#define CONFIG_DWC_AHSATA_PORT_ID 0
+#define CONFIG_DWC_AHSATA_BASE_ADDR SATA_ARB_BASE_ADDR
+#define CONFIG_LBA48
+#define CONFIG_LIBATA
+#endif
+
#define CONFIG_CMD_PING
#define CONFIG_CMD_DHCP
#define CONFIG_CMD_MII
--
1.7.9
More information about the U-Boot
mailing list