[U-Boot] [PATCH v2 1/2] CONFIG_SYS_BAUDRATE_TABLE: Add <config_fallbacks.h>, place there

Wolfgang Denk wd at denx.de
Fri Apr 27 18:17:49 CEST 2012


Dear Tom Rini,

In message <4F9AB2EE.3070202 at ti.com> you wrote:
>
> > Argh... But you cannot change this without explicit ACK from the
> > respective board maintainers.
> 
> Then we're really SOL here.  Even if we limit it to "I dropped 
> 300/600/900/1200/2400/4800 baud rate support, is that ok".

What's wrong with keeping a customizes #define for the boards that use
nonstandard settings?

> > Finally, your patch does not apply (I guess it is an incremental patch
> > over obsolete code?).
> 
> That's odd actually, it was on v2012.04'ish and a pull and rebase -q 
> went quietly.  It was build-tested on MAKEALL -a powerpc/arm/x86.

But you see the problem in the patch, don't you?

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
"It follows that any commander in chief who undertakes to carry out a
plan which he considers defective is at fault; he must put forth  his
reasons,  insist  of  the  plan being changed, and finally tender his
resignation rather than be the instrument of his army's downfall."
- Napoleon, "Military Maxims and Thought"


More information about the U-Boot mailing list