[U-Boot] [PATCH v2 1/2] CONFIG_SYS_BAUDRATE_TABLE: Add <config_fallbacks.h>, place there

[Tom Rini]

On 04/27/2012 09:17 AM, Wolfgang Denk wrote:
> Dear Tom Rini,
>
> In message<4F9AB2EE.3070202 at ti.com>  you wrote:
>>
>>> Argh... But you cannot change this without explicit ACK from the
>>> respective board maintainers.
>>
>> Then we're really SOL here.  Even if we limit it to "I dropped
>> 300/600/900/1200/2400/4800 baud rate support, is that ok".
>
> What's wrong with keeping a customizes #define for the boards that use
> nonstandard settings?

As I said in the commit message, I believe it was done for completeness 
rather than need, but if you like I can change it to just delete 
4800/9600/19200/38400/115200 (and reversed) and leave the rest alone. 
And then I'll drop it from the boards I own :)

>>> Finally, your patch does not apply (I guess it is an incremental patch
>>> over obsolete code?).
>>
>> That's odd actually, it was on v2012.04'ish and a pull and rebase -q
>> went quietly.  It was build-tested on MAKEALL -a powerpc/arm/x86.
>
> But you see the problem in the patch, don't you?

With it not applying? No...

-- 
Tom