[U-Boot] [PATCH 1/2] arm/km: add mv88e6352 configuration for kmnusa

[Prafulla Wadaskar]

> -----Original Message-----
> From: Valentin Longchamp [mailto:valentin.longchamp at keymile.com]
> Sent: 16 August 2012 16:55
> To: u-boot at lists.denx.de
> Cc: holger.brunck at keymile.com; Prafulla Wadaskar;
> valentin.longchamp at keymile.com
> Subject: [PATCH 1/2] arm/km: add mv88e6352 configuration for kmnusa
> 
> The kmnusa board uses a mv88e6352 switch that is connected to the main
> eth interface of the kirkwood. Therefore the switch must be configured
> so that the kirkwood's egiga eth inferface can be used.
> 
> Signed-off-by: Valentin Longchamp <valentin.longchamp at keymile.com>
> Cc: Holger Brunck <holger.brunck at keymile.com>
> Cc: Prafulla Wadaskar <prafulla at marvell.com>
> ---
>  board/keymile/km_arm/km_arm.c |   63
> +++++++++++++++++++++++++++++++++++++++++
>  1 files changed, 63 insertions(+), 0 deletions(-)
> 
> diff --git a/board/keymile/km_arm/km_arm.c
> b/board/keymile/km_arm/km_arm.c
> index 2b2ca39..c0069c1 100644
> --- a/board/keymile/km_arm/km_arm.c
> +++ b/board/keymile/km_arm/km_arm.c
> @@ -385,6 +385,69 @@ void reset_phy(void)
>  	/* reset the phy */
>  	miiphy_reset(name, CONFIG_PHY_BASE_ADR);
>  }
> +#elif defined(CONFIG_KM_PIGGY4_88E6352)
> +
> +#include <mv88e6352.h>
> +
> +#if defined(CONFIG_KM_NUSA)
> +struct mv88e_sw_reg extsw_conf[] = {
> +	/* port 0, PIGY4, autoneg */
> +	/* first the fix for the 1000Mbits Autoneg, this is from
> +	 * a Marvell errata, the regs are undocumented */

May you please follow standard c-style commenting?

Otherwise ack for this patch

Regards..
Prafulla .  .