[U-Boot] [PATCH 1/2] arm/km: add mv88e6352 configuration for kmnusa

[Valentin Longchamp]

On 08/17/2012 09:59 AM, Prafulla Wadaskar wrote:
> 
> 
>> -----Original Message-----
>> From: Valentin Longchamp [mailto:valentin.longchamp at keymile.com]
>> Sent: 16 August 2012 16:55
>> To: u-boot at lists.denx.de
>> Cc: holger.brunck at keymile.com; Prafulla Wadaskar;
>> valentin.longchamp at keymile.com
>> Subject: [PATCH 1/2] arm/km: add mv88e6352 configuration for kmnusa
>>
>> The kmnusa board uses a mv88e6352 switch that is connected to the main
>> eth interface of the kirkwood. Therefore the switch must be configured
>> so that the kirkwood's egiga eth inferface can be used.
>>
>> Signed-off-by: Valentin Longchamp <valentin.longchamp at keymile.com>
>> Cc: Holger Brunck <holger.brunck at keymile.com>
>> Cc: Prafulla Wadaskar <prafulla at marvell.com>
>> ---
>>  board/keymile/km_arm/km_arm.c |   63
>> +++++++++++++++++++++++++++++++++++++++++
>>  1 files changed, 63 insertions(+), 0 deletions(-)
>>
>> diff --git a/board/keymile/km_arm/km_arm.c
>> b/board/keymile/km_arm/km_arm.c
>> index 2b2ca39..c0069c1 100644
>> --- a/board/keymile/km_arm/km_arm.c
>> +++ b/board/keymile/km_arm/km_arm.c
>> @@ -385,6 +385,69 @@ void reset_phy(void)
>>  	/* reset the phy */
>>  	miiphy_reset(name, CONFIG_PHY_BASE_ADR);
>>  }
>> +#elif defined(CONFIG_KM_PIGGY4_88E6352)
>> +
>> +#include <mv88e6352.h>
>> +
>> +#if defined(CONFIG_KM_NUSA)
>> +struct mv88e_sw_reg extsw_conf[] = {
>> +	/* port 0, PIGY4, autoneg */
>> +	/* first the fix for the 1000Mbits Autoneg, this is from
>> +	 * a Marvell errata, the regs are undocumented */
> 
> May you please follow standard c-style commenting?
> 

OK, I will change this comment. Is it OK if I just repost this updated patch as
a reply to this message since it's a very minor change or do you need the whole
series ?

Thanks

Valentin