[U-Boot] [PATCH 04/16] Blackfin: Rsi: add support for bf609-ezkit

[Bob Liu]

On Wed, Aug 8, 2012 at 12:52 PM, Mike Frysinger <vapier at gentoo.org> wrote:
> On Tuesday 07 August 2012 04:07:43 Bob Liu wrote:
>> --- a/arch/blackfin/include/asm/config-pre.h
>> +++ b/arch/blackfin/include/asm/config-pre.h
>>
>>  #define BFIN_BOOT_16HOST_DMA  11      /* boot ldr from 16-bit host dma */
>>  #define BFIN_BOOT_8HOST_DMA   12      /* boot ldr from 8-bit host dma */
>>  #define BFIN_BOOT_NAND        13      /* boot ldr from nand flash */
>> +#define BFIN_BOOT_RSI_MASTER  14      /* boot ldr from rsi */
>> +#define BFIN_BOOT_LP_SLAVE    15      /* boot ldr from link port */
>>
>>     case BFIN_BOOT_16HOST_DMA: return "16bit dma";
>>       case BFIN_BOOT_8HOST_DMA:  return "8bit dma";
>>       case BFIN_BOOT_NAND:       return "nand flash";
>> +     case BFIN_BOOT_RSI_MASTER: return "rsi master";
>> +     case BFIN_BOOT_LP_SLAVE:   return "link port slave";
>>       default:                   return "INVALID";
>>       }
>>  }
>
> seems like a change that should be by itself, or squashed into the "core bf60x
> support" patch
>
>> --- a/arch/blackfin/include/asm/mach-common/bits/dma.h
>> +++ b/arch/blackfin/include/asm/mach-common/bits/dma.h
>
> should be part of the "bf60x dma" patch
>
>> --- a/arch/blackfin/include/asm/mach-common/bits/sdh.h
>> +++ b/arch/blackfin/include/asm/mach-common/bits/sdh.h
>> --- a/drivers/mmc/bfin_sdh.c
>> +++ b/drivers/mmc/bfin_sdh.c
>
> these are about the only changes that should be in this patch, and the subject
> should be:
>         Blackfin: rsi: add support for bf60x
>
>> --- a/board/bf609-ezkit/bf609-ezkit.c
>> +++ b/board/bf609-ezkit/bf609-ezkit.c
>> --- a/include/configs/bf609-ezkit.h
>> +++ b/include/configs/bf609-ezkit.h
>
> merge the rsi patch first, then squash this into the bf609-ezkit board patch

Okay.
-- 
Regards,
--Bob