[U-Boot] [PATCH V2 1/1] mx31/mx35/mx51/mx53/mx6: add watchdog

[Stefano Babic]

On 22/08/2012 20:30, Troy Kisky wrote:
> On 8/22/2012 12:22 AM, Stefano Babic wrote:
>> On 21/08/2012 19:51, Troy Kisky wrote:
>>> On 8/20/2012 11:11 PM, Stefano Babic wrote:
>>>> On 21/08/2012 01:03, Troy Kisky wrote:
>>>>

Hi Troy,

>>> So, you are saying CONFIG_ options don't belong in imx-regs.h, or
>>> you didn't notice I stuck it there, or both???
>> I didn't notice, but CONFIG_ options do not belong to imx-regs.h. They
>> must be define only inside the board configuration file.
>>
>> Best regards,
>> Stefano
>>
> Would it be acceptable to put
> #if defined(CONFIG_MX31) || defined(CONFIG_MX35) || defined(CONFIG_MX51) \
>     || defined(CONFIG_MX53) || defined(CONFIG_MX6Q)
> #define CONFIG_IMX_WATCHDOG    /* cpu_reset implemented in watchdog */
> #endif
> 
> 
> at the bottom of config_cmd_default.h or do you have a better place in
> mind?
> 

I do not think this will be accepted by Wolfgang. config_cmd_default.h
is a general file and should not have any reference to SOC specific details.

We have discussed recently how we can put common code across CPU
boundaries. I mean, code generic for all i.MXs (as in this case) that is
then replicated under cpu/arm1136, cpu/arm926ejs,...

Maybe we can start a new thread and ask Albert (I am already asking
him..) what he thinks about a arch/arm/cpu/plat-imx.

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================