[U-Boot] [PATCH v2 7/7] Tegra30: Add/enable Cardhu build (T30 reference board)

[Simon Glass]

Hi,

On Tue, Dec 4, 2012 at 2:41 PM, Stephen Warren <swarren at wwwdotorg.org> wrote:
> On 12/04/2012 01:40 PM, Lucas Stach wrote:
>> Hi Tom,
>>
>> Am Dienstag, den 04.12.2012, 13:22 -0700 schrieb Tom Warren:
>> [...]
>>>
>>>>
>>>>> +#define V_NS16550_CLK                        216000000       /* 216MHz (pllp_out0) */
>>>>
>>>> I thought PLL_P ran at 408MHz on Tegra30? The kernel certainly sets it
>>>> up that way.
>>>
>>> See my previous reply. In the internal U-Boot repo I ported from, PLLP
>>> was initially set to 216MHz, then sped up to 408MHz. When this first
>>> round of patches is in, I can address going to 408MHz first thing.
>>>
>> Is running the PLL_P at 408MHz something which requires a lot of work?
>> If not, please do this and fold it into this patchset. It doesn't look
>> too nice adding things to upstream which have to be changed/removed
>> immediately after going in.
>
> Naively I'd have to agree here; it seems that programming the PLL for
> the correct rate would probably "just work" right from the outset? After
> all, if the code runs OK with the higher rate enabled a little later in
> boot, I see no reason it shouldn't run OK with that exact same rate the
> whole way through.