[U-Boot] [PATCH 0/2] da850evm: add board specific functions

[Hadli, Manjunath]

Christian,

On Thu, Feb 02, 2012 at 19:56:45, Christian Riesch wrote:
> Hi,
> Thank you for re-submitting the patchset!
> 
> On Thu, Feb 2, 2012 at 2:42 PM, Manjunath Hadli <manjunath.hadli at ti.com> wrote:
> > There are two da850 SOC based EVMs, one from Spectrum digital and 
> > other from Logic PD. Boards from Spectrum digital have mac address 
> > stored in I2C EEPROM and they have spi flash manufactured by WINBOND. 
> > Boards from Logic PD store mac address in ST Microelectronics SPI 
> > flash. This patch series adds support to read mac address from the 
> > appropriate device.
> 
> Ok, so we have two configurations, we have da850evm which is for LogicPD's OMAP-L138 SoM and for LogicPD's AM1808 SoM, and we have da850_am18xxevm which must be used for the AM1808 board from Spectrum Digital. Is that correct?
Yes.
> 
> I wonder if we should change the name of the da850_am18xxevm configuration. It's quite confusing, until today I thought that the da850_am18xxevm was a configuration for LogicPD's AM1808 SoM... Are there also OMAP-L138 boards from Spectrum Digital?
Spectrum Digital do not have any OMAP-L138 EVMs. They have only AM18x evms.

Regards,
--Manju

> 
> Regards, Christian
> 
> >
> > These patches have undergone a review previously, but since the tree 
> > has moved ahead Christian and Tom asked to resubmit the patches for 
> > review.
> > (http://www.mail-archive.com/u-boot@lists.denx.de/msg76220.html)
> >
> > Manjunath Hadli (2):
> >  da850evm: add support to read mac address from spi flash
> >  da850evm: read mac address from I2C EEPROM on AM18x EVM
> >
> >  board/davinci/da8xxevm/da850evm.c |   66 
> > +++++++++++++++++++++++++++++++++++++
> >  boards.cfg                        |    4 +-
> >  2 files changed, 68 insertions(+), 2 deletions(-)
> >
> > _______________________________________________
> > U-Boot mailing list
> > U-Boot at lists.denx.de
> > http://lists.denx.de/mailman/listinfo/u-boot
>