[U-Boot] [PATCH 2/4] arm: add %function attribute to assembly functions

[Albert ARIBAUD]

Hi Aneesh,

Le 17/02/2012 12:09, Aneesh V a écrit :
> Hi Albert,
>
> On Wednesday 15 February 2012 07:27 PM, Aneesh V wrote:
>> This is done using the following directive preceding
>> each function definition:
>>
>> .type<func-name>, %function
>>
>> This marks the symbol as a function in the object
>> header which in turn helps the linker in some cases.
>>
>> In particular this was found needed for resolving ARM/Thumb
>> calls correctly in a build with Thumb interworking enabled.
>>
>> This solves the following problem I had reported earlier:
>>
>> "When U-Boot/SPL is built using the Thumb instruction set the
>> toolchain has a potential issue with weakly linked symbols.
>> If a function has a weakly linked default implementation in C
>> and a real implementation in assembly GCC is confused about the
>> instruction set of the assembly implementation. As a result
>> the assembly function that is built in ARM is executed as
>> if it is Thumb. This results in a crash"
>>
>> Signed-off-by: Aneesh V<aneesh at ti.com>
>
> Does this look good to you. I was a bit nervous about touching so many
> files. Please let me know if you would prefer to change only the OMAP
> function that was creating the ARM/Thumb problem. I did a "MAKEALL -a
> arm" and didn't see any new errors.
>
> Let me know if this is an acceptable solution to the problem.

Regarding the solution: it is quite ok to me. I would just like to 
understand the exact effect of the .function directive, what its options 
are and if some of these should not be explicitly specified.

Regarding touching many files: I won't be worried as long as you check 
that the first three patches have no effect on existing boards. This can 
be verified as follows -- if you haven't done so already:

- build your OMAP target without the patch set and do a hex dump of 
u-boot.bin;

- apply the first three patches of your set, rebuild your OMAP target 
without the patch set and do a hex dump of u-boot.bin;

- compare both dumps. Normally you should only see one difference, in 
the build version and date -- if .function does not actually alter the 
assembly code, which I hope it indeed does not when building for ARM.

If there are more changes than build version and date, then they might 
be due to .function requiring some yet unknown additional option, or to 
some change in patch 1 or 3 not being completely conditioned on 
CONFIG_SYS_THUMB_BUILD.

> regards,
> Aneesh

Amicalement,
-- 
Albert.