[U-Boot] [RFC PATCH 0/19] Create generic board init and move ARM and x86 to it

[Simon Glass]

Hi Wolfgang,

On Tue, Jan 3, 2012 at 2:35 PM, Wolfgang Denk <wd at denx.de> wrote:
> Dear Simon Glass,
>
> In message <CAPnjgZ3592m_m=TMaFptwzO+_O94veYkVRFFdGPP599igefNyg at mail.gmail.com> you wrote:
>>
>> I have brought in PPC to board_f.c and board_r.c but not dealt with
>> relocation. Once I have done that, gone through the new x86 series
>> again and MAKEALL doesn't scream too loudly I'll do another RFC along
>> these lines.
>
> I'm seriously concerned about you insisting to include relocation
> here.  This has nothign to do with it.  Leave that out.

I'm not insisting, only that I have already done a series for generic
relocation so figured this new series would come second. I did signal
this right at the beginning when suggesting the approach:

http://lists.denx.de/pipermail/u-boot/2011-November/109987.html

Anyway, leaving out relocation is easier so I will rebase this series
on top of master instead.

Regards,
Simon

>
> Best regards,
>
> Wolfgang Denk
>
> --
> DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
> HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
> Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
> "When the only  tool  you  have  is  a  hammer,  you  tend  to  treat
> everything as if it were a nail."                    - Abraham Maslow