[U-Boot] [PATCH 1/1] ipu common: reset ipuv3 correctly

[Liu Ying]

From: Liu Ying <Ying.Liu at freescale.com>

This patch checks self-clear sw_ipu_rst bit in
SCR register of SRC controller to be cleared
after setting it to high to reset IPUv3. This
makes sure that IPUv3 finishes sofware reset.
A timeout mechanism is added to stop polling
on the bit status in case the bit could not be
cleared by the hardware automatically within
10 millisecond.

Signed-off-by: Liu Ying <Ying.Liu at freescale.com>
---
 drivers/video/ipu_common.c |   10 ++++++++++
 1 files changed, 10 insertions(+), 0 deletions(-)

diff --git a/drivers/video/ipu_common.c b/drivers/video/ipu_common.c
index 2020da9..fcc1745 100644
--- a/drivers/video/ipu_common.c
+++ b/drivers/video/ipu_common.c
@@ -94,6 +94,7 @@ struct ipu_ch_param {
 	temp1; \
 })
 
+#define IPU_SW_RST_TOUT_USEC	(10000)
 
 void clk_enable(struct clk *clk)
 {
@@ -392,11 +393,20 @@ void ipu_reset(void)
 {
 	u32 *reg;
 	u32 value;
+	int timeout = IPU_SW_RST_TOUT_USEC;
 
 	reg = (u32 *)SRC_BASE_ADDR;
 	value = __raw_readl(reg);
 	value = value | SW_IPU_RST;
 	__raw_writel(value, reg);
+
+	while (__raw_readl(reg) & SW_IPU_RST) {
+		udelay(1);
+		if (!(timeout--)) {
+			printf("ipu software reset timeout\n");
+			break;
+		}
+	};
 }
 
 /*
-- 
1.7.1