[U-Boot] mx6qsabrelite: commands not recognized

Fabio Estevam festevam at gmail.com
Thu Oct 25 15:28:49 CEST 2012


Hi,

Using the latest u-boot-imx tree, I am getting the following on a mx6qsabrelite:

U-Boot 2012.10-09478-gab857f2 (Oct 25 2012 - 11:24:04)

CPU:   Freescale i.MX6Q rev1.0 at 792 MHz
Reset cause: POR
Board: MX6Q-Sabre Lite
DRAM:  1 GiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
auto-detected panel HDMI
enable_hdmi: setup HDMI monitor
Display: HDMI (1024x768)
In:    serial
Out:   serial
Err:   serial
Net:   FEC [PRIME]
Warning: failed to set MAC address

Hit any key to stop autoboot:  0
MX6QSABRELITE U-Boot > save
Unknown command 'save' - try 'help'
MX6QSABRELITE U-Boot >

Basically no commands are recognized.

Haven't started bisecting this yet, but just wanted to check if others
see the same issue.

Thanks,

Fabio Estevam


More information about the U-Boot mailing list