[U-Boot] mx6qsabrelite: commands not recognized

Eric Nelson eric.nelson at boundarydevices.com
Thu Oct 25 16:07:38 CEST 2012


Hi Fabio,

On 10/25/2012 06:28 AM, Fabio Estevam wrote:
> Hi,
>
> Using the latest u-boot-imx tree, I am getting the following on a mx6qsabrelite:
>
> U-Boot 2012.10-09478-gab857f2 (Oct 25 2012 - 11:24:04)
>
> CPU:   Freescale i.MX6Q rev1.0 at 792 MHz
> Reset cause: POR
> Board: MX6Q-Sabre Lite
> DRAM:  1 GiB
> MMC:   FSL_SDHC: 0, FSL_SDHC: 1
> auto-detected panel HDMI
> enable_hdmi: setup HDMI monitor
> Display: HDMI (1024x768)
> In:    serial
> Out:   serial
> Err:   serial
> Net:   FEC [PRIME]
> Warning: failed to set MAC address
>
> Hit any key to stop autoboot:  0
> MX6QSABRELITE U-Boot>  save
> Unknown command 'save' - try 'help'
> MX6QSABRELITE U-Boot>
>
> Basically no commands are recognized.
>
> Haven't started bisecting this yet, but just wanted to check if others
> see the same issue.
>

You might want to check how you're programming this.

I saw this issue when U-Boot first went above 256k (the SPI-NOR
upgrade script only erased 0x40000 bytes).

I'll test later today.

Regards,

Eric


More information about the U-Boot mailing list