[U-Boot] upstream Arndale support

[Chander Kashyap]

Hi Andre,

On 4 December 2013 17:09, Andre Przywara <andre.przywara at linaro.org> wrote:
> Hi,
>
> I cannot get upstream u-boot to run on an Arndale board. Everything works
> when I use the Linaro branch. But this tree is old and carries a whole
> different set of patches for Arndale.
> Is the Arndale upstream support supposed to work? If yes, is there a
> different recipe for populating the uSD card?
>
> What works is the following:
> $ git checkout linaro
> $ make arndale5250_config && make -j arndale5250
> $ dd if=/tmp/arndale-bl1.bin of=/dev/sdb seek=1
> $ dd if=spl/smdk5250-spl.bin of=/dev/sdb seek=17
> $ dd if=u-boot.bin of=/dev/sdb seek=49
>
> Transferring this to upstream I get the following:
> $ git checkout master
> $ make arndale_config && make -j arndale
> $ dd if=/tmp/arndale-bl1.bin of=/dev/sdb seek=1
> $ dd if=spl/arndale-spl.bin of=/dev/sdb seek=17
> $ dd if=u-boot.bin of=/dev/sdb seek=49
dd if=u-boot-dtb.bin of=/dev/sdb seek=49
>
> However while the Linaro based build works fine, I don't get any serial
> output on the upstream build.
>
> Can someone give any hints?
>
> Thanks,
> Andre.



-- 
with warm regards,
Chander Kashyap