[U-Boot] upstream Arndale support

[Andre Przywara]

On 12/04/2013 01:14 PM, Chander Kashyap wrote:
> Hi Andre,
>
> On 4 December 2013 17:09, Andre Przywara <andre.przywara at linaro.org> wrote:
>> Hi,
>>
>> I cannot get upstream u-boot to run on an Arndale board. Everything works
>> when I use the Linaro branch. But this tree is old and carries a whole
>> different set of patches for Arndale.
>> Is the Arndale upstream support supposed to work? If yes, is there a
>> different recipe for populating the uSD card?
>>
>> What works is the following:
>> $ git checkout linaro
>> $ make arndale5250_config && make -j arndale5250
>> $ dd if=/tmp/arndale-bl1.bin of=/dev/sdb seek=1
>> $ dd if=spl/smdk5250-spl.bin of=/dev/sdb seek=17
>> $ dd if=u-boot.bin of=/dev/sdb seek=49
>>
>> Transferring this to upstream I get the following:
>> $ git checkout master
>> $ make arndale_config && make -j arndale
>> $ dd if=/tmp/arndale-bl1.bin of=/dev/sdb seek=1
>> $ dd if=spl/arndale-spl.bin of=/dev/sdb seek=17
>> $ dd if=u-boot.bin of=/dev/sdb seek=49
> dd if=u-boot-dtb.bin of=/dev/sdb seek=49

Indeed! That works!

Thanks a lot!

Andre.

>>
>> However while the Linaro based build works fine, I don't get any serial
>> output on the upstream build.
>>
>> Can someone give any hints?
>>
>> Thanks,
>> Andre.
>
>
>