[U-Boot] [PATCH 00/13] mxc nand: Add support for i.MX5

[Marek Vasut]

Dear Scott Wood,

> On 01/07/2013 07:47:12 AM, Marek Vasut wrote:
> > Dear Benoît Thébaudeau,
> > 
> > > Dear Marek Vasut,
> > > 
> > > On Monday, January 7, 2013 2:02:47 PM, Marek Vasut wrote:
> > > > Dear Benoît Thébaudeau,
> > > > 
> > > > > Hi all,
> > > > > 
> > > > > This series aims at adding support for i.MX5 to the mxc nand mtd
> > > > > and spl
> > > > > drivers. It also fixes several issues and cleans up the code a
> > > > > little bit.
> > > > > 
> > > > > Best regards,
> > > > > Benoît
> > > > 
> > > > Did this patchset advance any further? Any chance we can see this
> > > > applied?
> > > > Anything I can help with to make it applied?
> > > 
> > > Only 13/13 has not yet been applied. I still have to add NFC
> > 
> > support to one
> > 
> > > i.MX5 board for the patch to be accepted. Fabio has confirmed that
> > 
> > mx53ard
> > 
> > > would be fine.
> > 
> > Sigh ... I have board with NAND pending, so Scott, please apply.
> 
> Can you repost it as part of a patchset with that board, and I'll ack
> so they can go together?

I found an issue with the patch, so will do.

> Does this board do NAND boot?

No, boots from other means.

> If so, new-SPL rather than nand_spl
> would be nice.  Tom's comment at the time was, "I'm OK with pulling
> this in while providing an on-the-record prod to please find some time
> to do a conversion or two in time for v2013.01."  If this patch is
> applied now, it would be for the release after v2013.01...

No prob.

> -Scott

Best regards,
Marek Vasut