[U-Boot] mpc512x: Trouble migrating from 2012.07 to 2013.01

Wolfgang Denk wd at denx.de
Wed Jan 23 21:40:52 CET 2013


Dear Mats,

In message <ED3E0BCACD909541BA94A34C4A164D4C427B39B4 at post.tritech.se> you wrote:
> 
> Question: To help me decide where to look I would like to know if anyone has built the mpc5121ads board configuration using U-Boot 2013.01 and actually tested that it is still working?

Yes, v2012.01 is working on the MPC5121ADS board:

U-Boot 2013.01 (Jan 23 2013 - 21:37:51)MPC512X

CPU:   MPC5121e rev. 2.0, Core e300c4 at 400 MHz, CSB at 200 MHz
(RSR=0x1003)
Board: MPC5121ADS rev. 0x0400 (CPLD rev. 0x05)
I2C:   ready
DRAM:  512 MiB
Flash: 64 MiB
NAND:  1024 MiB
PCI:   Bus Dev VenId DevId Class Int
In:    serial
Out:   serial
Err:   serial
Net:   FEC
IDE:   Bus 0:
............................................................** Timeout **

Type run flash_nfs to mount root filesystem over NFS

Hit any key to stop autoboot:  0 
=> 



Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
In any group of employed individuals the only naturally  early  riser
is  _always_  the office manager, who will _always_ leave reproachful
little notes ... on the desks of their subordinates.
                                - Terry Pratchett, _Lords and Ladies_


More information about the U-Boot mailing list