[U-Boot] [PATCH 1/5] MIPS: start.S: fix boundary check in relocate_code

[Gabor Juhos]

The loop code copies more data with one than
necessary due to the 'ble' instuction. Use the
'blt' instruction instead to fix that.

Due to the lack of suitable hardware the Xburst
specific code is compile tested only. However the
change is quite obvious.

Signed-off-by: Gabor Juhos <juhosg at openwrt.org>
Cc: Daniel Schwierzeck <daniel.schwierzeck at googlemail.com>
---
 arch/mips/cpu/mips32/start.S |    2 +-
 arch/mips/cpu/mips64/start.S |    2 +-
 arch/mips/cpu/xburst/start.S |    2 +-
 3 files changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/mips/cpu/mips32/start.S b/arch/mips/cpu/mips32/start.S
index 22a9c1b..a4fc1ec 100644
--- a/arch/mips/cpu/mips32/start.S
+++ b/arch/mips/cpu/mips32/start.S
@@ -313,7 +313,7 @@ relocate_code:
 	lw	t3, 0(t0)
 	sw	t3, 0(t1)
 	addu	t0, 4
-	ble	t0, t2, 1b
+	blt	t0, t2, 1b
 	 addu	t1, 4
 
 	/* If caches were enabled, we would have to flush them here. */
diff --git a/arch/mips/cpu/mips64/start.S b/arch/mips/cpu/mips64/start.S
index bc7e41e..aed82e1 100644
--- a/arch/mips/cpu/mips64/start.S
+++ b/arch/mips/cpu/mips64/start.S
@@ -192,7 +192,7 @@ relocate_code:
 	lw	t3, 0(t0)
 	sw	t3, 0(t1)
 	daddu	t0, 4
-	ble	t0, t2, 1b
+	blt	t0, t2, 1b
 	 daddu	t1, 4
 
 	/* If caches were enabled, we would have to flush them here. */
diff --git a/arch/mips/cpu/xburst/start.S b/arch/mips/cpu/xburst/start.S
index 3a8280c..194d745 100644
--- a/arch/mips/cpu/xburst/start.S
+++ b/arch/mips/cpu/xburst/start.S
@@ -87,7 +87,7 @@ relocate_code:
 	lw	t3, 0(t0)
 	sw	t3, 0(t1)
 	addu	t0, 4
-	ble	t0, t2, 1b
+	blt	t0, t2, 1b
 	 addu	t1, 4
 
 	/* If caches were enabled, we would have to flush them here. */
-- 
1.7.10