[U-Boot] [PATCH] mxs: Reset the EMI block on mx23

[Marek Vasut]

The real reason for memory instability was the fact that the EMI block
was gated and not reset throughout the boards' operation. This patch
resets the EMI block properly while also reverts the memory voltage bump.
The memory stability issues were caused by the EMI not being reset properly
and thus there is no longer need to run the memory at higher voltage than
it ought to run at.

This partly reverts 8303ed128a55519f19c5f11087032d4bc4e0537a .

Signed-off-by: Marek Vasut <marex at denx.de>
Cc: Fabio Estevam <fabio.estevam at freescale.com>
Cc: Otavio Salvador <otavio at ossystems.com.br>
Cc: Stefano Babic <sbabic at denx.de>
---
 arch/arm/cpu/arm926ejs/mxs/spl_mem_init.c |   11 +++++++++--
 1 file changed, 9 insertions(+), 2 deletions(-)

NOTE: Please apply _SEVERE_ testing!

diff --git a/arch/arm/cpu/arm926ejs/mxs/spl_mem_init.c b/arch/arm/cpu/arm926ejs/mxs/spl_mem_init.c
index f8392f6..20833f5 100644
--- a/arch/arm/cpu/arm926ejs/mxs/spl_mem_init.c
+++ b/arch/arm/cpu/arm926ejs/mxs/spl_mem_init.c
@@ -229,7 +229,7 @@ static void mx23_mem_setup_vddmem(void)
 	struct mxs_power_regs *power_regs =
 		(struct mxs_power_regs *)MXS_POWER_BASE;
 
-	writel((0x12 << POWER_VDDMEMCTRL_TRG_OFFSET) |
+	writel((0x10 << POWER_VDDMEMCTRL_TRG_OFFSET) |
 		POWER_VDDMEMCTRL_ENABLE_ILIMIT |
 		POWER_VDDMEMCTRL_ENABLE_LINREG |
 		POWER_VDDMEMCTRL_PULLDOWN_ACTIVE,
@@ -237,13 +237,20 @@ static void mx23_mem_setup_vddmem(void)
 
 	early_delay(10000);
 
-	writel((0x12 << POWER_VDDMEMCTRL_TRG_OFFSET) |
+	writel((0x10 << POWER_VDDMEMCTRL_TRG_OFFSET) |
 		POWER_VDDMEMCTRL_ENABLE_LINREG,
 		&power_regs->hw_power_vddmemctrl);
 }
 
 static void mx23_mem_init(void)
 {
+	/*
+	 * Reset/ungate the EMI block. This is essential, otherwise the system
+	 * suffers from memory instability. This thing is mx23 specific and is
+	 * no longer present on mx28.
+	 */
+	mxs_reset_block(MXS_EMI_BASE);
+
 	mx23_mem_setup_vddmem();
 
 	/*
-- 
1.7.10.4