[U-Boot] Please pull u-boot-ti/master

Lubomir Popov lpopov at mm-sol.com
Sat Jun 8 22:43:32 CEST 2013


Hi Tom, Michael,

> Hello,
>
> The following changes since commit 3da0e5750b24a9491058df6126c7be577a276c09:
>
>   arm: factorize relocate_code routine (2013-05-30 20:24:38 +0200)
>
> are available in the git repository at:
>
>   git://git.denx.de/u-boot-ti.git master
>
> for you to fetch changes up to 80dd596d1b442ff53dbeb33eccdb8efd2283be79:
>

[snip]

> Michael Trimarchi (1):
>       usb: omap: ulpi: fix ulpi transceiver access

[snip]

>  drivers/usb/ulpi/omap-ulpi-viewport.c              |   40 +-

[snip]

I just made a clean clone of u-boot-ti/master, manually applied the
changes to the ehci files, added my board files and made a build.
Everything seems to work fine, but I see an error message regarding
ULPI reset that was not present before, and obviously it is due to
Michael's changes:

SOM5_EVB # usb start
(Re)start USB...
USB0:   ULPI: ulpi_reset: failed writing reset bit
USB EHCI 1.00
scanning bus 0 for devices... 6 USB Device(s) found
       scanning usb for storage devices... 3 Storage Device(s) found
       scanning usb for ethernet devices... 1 Ethernet Device(s) found
SOM5_EVB # usb tree
USB device tree:
  1  Hub (480 Mb/s, 0mA)
  |  u-boot EHCI Host Controller
  |
  +-2  Mass Storage (480 Mb/s, 200mA)
  |    FSC                  MEMORYBIRD USB2      C157040817120315AA
  |
  +-3  Hub (480 Mb/s, 2mA)
  | |
  | +-4  Mass Storage (480 Mb/s, 96mA)
  | |    Generic Ultra Fast Media Reader 000000264001
  | |
  | +-5  Mass Storage (480 Mb/s, 100mA)
  |      USB Flash Drive 531C43B21928F11F
  |
  +-6  Vendor specific (480 Mb/s, 500mA)

SOM5_EVB #

Otherwise everything is OK, the device on the ULPI port is working
(it is #2 above). It is now late and I shall investigate in detail
tomorrow, this is just an early warning ;)

Best regards,
Lubo



More information about the U-Boot mailing list